Cisco Catalyst 4500 Series - Page 25

Contents
xxiii
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Selective Q-in-Q on a Trunk Port 27-12
About Layer 2 Protocol Tunneling 27-13
Configuring Layer 2 Protocol Tunneling 27-15
Default Layer 2 Protocol Tunneling Configuration 27-16
Layer 2 Protocol Tunneling Configuration Guidelines 27-16
Configuring Layer 2 Tunneling 27-17
Monitoring and Maintaining Tunneling Status 27-18
CHAPTER 28 Configuring CDP 28-1
About CDP 28-1
Configuring CDP 28-2
Enabling CDP Globally 28-2
Displaying the CDP Global Configuration 28-2
Enabling CDP on an Interface 28-3
Displaying the CDP Interface Configuration 28-3
Monitoring and Maintaining CDP 28-3
CHAPTER 29 Configuring LLDP, LLDP-MED, and Location Service 29-1
About LLDP, LLDP-MED, and Location Service 29-1
LLDP 29-1
LLDP-MED 29-2
Location Service 29-3
Configuring LLDP and LLDP-MED, and Location Service 29-4
Default LLDP Configuration 29-5
Configuring LLDP Characteristics 29-5
Disabling and Enabling LLDP Globally 29-6
Disabling and Enabling LLDP on an Interface 29-7
Configuring LLDP-MED TLVs 29-9
Configuring Network-Policy Profile 29-10
Configuring LLDP Power Negotiation 29-11
Configuring Location TLV and Location Service 29-12
Monitoring and Maintaining LLDP, LLDP-MED, and Location Service 29-14
Cisco IOS Carries Ethernet Features in Cisco IOS XE 3.1.0SG 29-15
CHAPTER 30 Configuring UDLD 30-1
About UDLD 30-1
UDLD Topology 30-2
Fast UDLD Topology 30-2