Cisco Catalyst 4500 Series - Page 49

Contents
xlvii
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
CHAPTER 62 Configuring Flexible NetFlow 62-1
CHAPTER 63 Configuring Ethernet OAM and CFM 63-1
About Ethernet CFM 63-2
Ethernet CFM and OAM Definitions 63-2
CFM Domain 63-2
Maintenance Associations and Maintenance Points 63-4
CFM Messages 63-5
Crosscheck Function and Static Remote MEPs 63-5
SNMP Traps and Fault Alarms 63-5
Configuration Error List 63-6
IP SLAs Support for CFM 63-6
Configuring Ethernet CFM 63-6
Ethernet CFM Default Configuration 63-7
Ethernet CFM Configuration Guidelines 63-7
Configuring the CFM Domain 63-8
Configuring Ethernet CFM Crosscheck 63-11
Configuring Static Remote MEP 63-13
Configuring a Port MEP 63-14
Configuring SNMP Traps 63-16
Configuring Fault Alarms 63-16
Configuring IP SLAs CFM Operation 63-18
Manually Configuring an IP SLAs CFM Probe or Jitter Operation 63-19
Configuring an IP SLAs Operation with Endpoint Discovery 63-21
Configuring CFM on C-VLAN (Inner VLAN) 63-24
Feature Support and Behavior 63-26
Platform Restrictions and Limitations 63-26
Understanding CFM ITU-T Y.1731 Fault Management 63-27
Y.1731 Terminology 63-27
Alarm Indication Signals 63-28
Ethernet Remote Defect Indication 63-28
Multicast Ethernet Loopback 63-29
Configuring Y.1731 Fault Management 63-29
Default Y.1731 Configuration 63-29
Configuring ETH-AIS 63-29
Using Multicast Ethernet Loopback 63-31
Managing and Displaying Ethernet CFM Information 63-31
About Ethernet OAM Protocol 63-33
OAM Features 63-34