2 Select PE Resync: All. The receiver will synchronize the PE output according to
the services and then the PIDs assigned to each service.
To synchronize the output to a Template:
Using a template allows you to preset the input to output mapping of a PE according
to the preset template. This is helpful in pre-configuring any number of PEs for
future use.
TS Out - Options
To view the Options menu from the TS Out menu, press the RIGHT arrow key four
times.
The Options menu allows you to configure auto synchronization and fixed output
options for the MPEG over IP and ASI outputs.
The Options menu has the following structure:
Select 1 to configure the ASI
output or select 2 to configure
the MPEG over IP output.
To Next Page
Loading...
