Configuring System Settings
System Logs
From the Syslog drop-down list, choose the logging protocol to use (Syslog TCP or
Syslog UDP). The Legacy option is used by Cisco customer support only. Choose
Disable to disable system logging.
If Syslog TCP or Syslog UDP is selected, enter the IP address of the server in the
Syslog Server IP Address field and the server UDP or TCP port number in the
Syslog Server Port field.
We highly recommend that you use the following syslog servers:
 Syslog-ng - Balabit for Linux (http://www.balabit.com/network-
security/syslog-ng/opensource-logging-system)
 Syslog Watcher - SnmpSoft for Windows
(http://www.snmpsoft.com/downloads.html)
The following is an example of a syslog:
Setting Up Redundancy Controls
The Redundancy Control area allows you to configure redundancy for MPEG over
IP and MPE outputs when an active port fails due to a physical connectivity loss.
The data port 1 is labeled as TS 2, and the data port 2 is labeled as TS 3 on the rear
connector panel. For more information, see D9824 Receiver Rear Connector Panel
(on page 23).
1 In the IP Settings page (System Settings > IP Settings), refer to the Redundancy
Control area.
2 From the Mode drop-down list, choose the redundancy mode for MPEG over IP
and MPE data.
To Next Page
Loading...
Need help?
General
