Cisco D9824 - Page 341

319
Alarm
Message
Type
Message
Cause/Remedy
Description
Severity
ID
FPGA status
Set
FPGA Done failed
to go high
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major
39000
FPGA status
Set
SW ver outside
upper or lower
limit
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major
39000
FPGA status
Set
FPGA ID does not
match FPGA
DESIGNATION
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major
39000
FPGA status
Set
FPGA ID does not
match HW FPGA
ID
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major
39000
FPGA status
Clear
FPGA loaded
successfully and
reset
–
–
Major
39000
MPoIP Engine
Failure
Set
Critical MPoIP
engine failure, all
active streams
must be restarted
Cause: MPEG over
IP engine failure.
Remedy: Restart
all the streams.
Indicates that
MPoIP delay
FIFO is
overflowing.
This is a critical
error.
Major
92200
MPoIP Engine
Failure
Clear
Error cleared
–
–
Major
92200