Cisco D9824 User Manual

Chapter 4 Front Panel Operation
68
Menu Item
Description
Parameters
CA Ctl
Sets how the conditional access will attempt to
descramble the scrambled programs. The
behavior of this setting is different between
PowerVu streams and those that require a
CAM.
For PowerVu streams:
Std - In standard mode, if
a program is not
authorized, even if some
services are not scrambled,
the whole program will
not be authorized.
Open - In open mode, if a
program is not authorized,
services in the program
that are not scrambled will
still be available.
For Non-PowerVu (CAM)
streams:
Std - In standard mode, if
a program’s CA system is
not supported by the
CAM, the channel is not
authorized.
Open - In open mode, all
the program’s CA systems
are validated by the CAM.
The channel is always
authorized.
Select
Sets the method used by the RF tuner to
determine which input to use when switching
transports.
UserCfg - User
configuration will only use
the active RF input.
SW Map - Software map
uses the orbital position
settings from each input
and map it to those in the
NIT.
LO1 (GHz)
Sets the lower oscillator frequency, in GHz, of
the LNB. In a single band oscillator, set its
frequency, in GHz.
0.0 to 15.0 GHz. Must be
lower than the value for
LO2.
LO2 (GHz)
Sets the higher oscillator frequency, in GHz, of
the LNB. In a single band oscillator, set this
value to 0.0.
0.0 to 15.0 GHz. Must be
higher than the value for
LO1.
Crossover (GHz)
This is the crossover frequency, which is an
internal threshold frequency used for selecting
the LO1 or LO2 frequency, depending on the
current Downlink frequency settings. This
option is only used in dual-band LNB
applications.
0.0 to 15.0 GHz. In single-
band LNB applications, set
this value to 0.0.

Cisco D9824 Specifications

General

Brand	Cisco
Model	D9824
Category	Receiver
Language	English