Sets how the conditional access will
attempt to descramble the scrambled
programs. The behavior of this setting
is different between PowerVu streams
and those that require a CAM.
For PowerVu streams:
Std - In standard mode, if a
program is not authorized, even if
some services are not scrambled,
the whole program will not be
authorized.
Open - In open mode, if a program
is not authorized, services in the
program that are not scrambled
will still be available.
For Non-PowerVu (CAM) streams:
Std - In standard mode, if a
program’s CA system is not
supported by the CAM, the
channel is not authorized.
Open - In open mode, all the
program’s CA systems are
validated by the CAM. The
channel is always authorized.
RF1, RF2, RF3, RF4 (RFx) Input
RFx Active (RF1,
RF2, RF3, RF4)
Select the input to be active.
Note: Setting a new input to be active will
deactivate the currently active input.
Select which tables are required for the service
list creation and signal acquisition.
Note: When editing the tuning, the device is in
a transient state while acquiring tuning
information and channel lists, and so on. The
receiver reverts to the previous set of tuning
settings/information and channels until these
changes are either saved or abandoned.
Basic - Requires NIT to be
present.
Auto - Uses all the service
list tables and it will
acquire if any service list
tables are present.
Custom - Uses the Custom
Tuning parameters,
specified by the user.
The default is Basic.
To Next Page
Loading...
Need help?
General
