Cisco D9824 - Page 96

Chapter 4 Front Panel Operation
74
Menu Item
Description
Parameters
DATA1/DATA2
Displays whether the detected host (Source IP
Select) is available on DATA1 and/or DATA2
ports.
Yes or No
Algorithm
The de-jitter algorithm.
VBR, CBR
Latency (ms)
Buffer latency (delay), in milliseconds.
110 to 150 if VBR is
selected as the Algorithm.
40 to 150 if CBR is selected
as the Algorithm.
Redundancy Mode
Select the type of redundancy for the MOIP
input data.
Manual Data1/Data2 -
Only use Data1 (port 1) or
Data2 (port 2) for input
data. The remaining
redundancy controls
below are not applicable.
Backup: Primary
Data1/Data2 - Use port 1
or port 2 as the primary
data port. If an issue
occurs, it will failover to
port 2 or port 1 (the
backup port).
Type
If Backup: Primary Data1/Data2 is set as the
Redundancy mode, select the redundancy
direction.
Revertive - Attempt to
revert back to the primary
port when using the
backup port and the
primary port is active
again.
Non-revertive - Use the
backup port (if active)
when the primary port
fails, without reverting
back to the primary port,
under any condition.
Direct Delay
Time to wait before switching from the
primary data port to the backup data port after
the system detects a failure on the primary
port.
0 to 1000 milliseconds
Revertive Delay
Time to wait before reverting back to the
primary port once the primary port is active
again.
Note: If Non-Revertive is set as the Type, this
field does not apply.
0 to 30 seconds