Pass (default) - Output channel is the
same as the input channel. The
OutCh, and PMT settings are ignored.
All PID map entries are ignored
except for entries that explicitly drop
a service.
Map - The output channel is mapped
to the OutCh and PMT settings. Only
services which have entries in the PID
map are available on the output.
These services will appear in the PMT
even if the stream is not present.
Note: If the PE is mapped, it uses the
last valid (or saved) configuration.
The output map (for example, output
channel PMT) does not change
automatically if the input or channel
number is changed.
Drop - The current channel is not sent
to the output and its PMT is removed
from the output. The OutCh, PMT,
and PID map entries are ignored.
XCode - Provides the flexibility to
define all the outgoing PID numbers
for a PE, including those not currently
on transmission, as in Map mode,
plus the video PID is transcoded to
output at the rate and settings defined
for the transcode channel.
Note: The Auxiliary Programs (P1A
and P2A) cannot be set to XCode.
Also, they are automatically dropped
when the corresponding Main PE is
not transcoding.
To Next Page
Loading...
Need help?
General
