Chapter 4 Front Panel Operation
PE Resync: All,
Template, PIDs, Svcs
Each PE output can be
synchronized to its input
according to one of four output
modes. For information on
synchronizing output services,
see Synchronizing Output
Services (on page 108).
Svcs - Map the input to the output
based on the services only.
PIDS - Map the input to the output
based on the PIDs only.
All - Map the input to the output
based on the PIDs and services
Template - Map the input to a fixed
template output.
This is a customer-specific
mode, only to be used if
directed by Cisco. For more
information, contact Cisco
customer support.
This is a customer-specific
mode, only to be used if
directed by Cisco. For more
information, contact Cisco
customer support.
PID Map Menu
This menu allows the PID Map to be configured. The PID map is used to map input
services to output PIDs.
If the PE action is Pass, or PE action is Map and Map Mode is Svc ID, only entries
which drop a service are applied and all other services are passed through. If the PE
action is Map and Map Mode is Svc ID & PID, all entries are applied. Any services
not mapped by an entry will be dropped.
Press up and down to scroll through the PID map entries. Press ADV to insert or
delete entries from the PID map. After inserting an entry, specify the service using
OutType and In, and set the desired Action. If the action is Map, select the output
PID value as well. Then press APPLY and save the settings to see the selected input
service that will follow that mapping.
Displays the input service that
will be mapped by the current
entry. This value is read-only
and for reference purposes.
Displays the input PID that will
be mapped by the current
entry. This value is read-only
and for reference purposes.
To Next Page
Loading...
Need help?
General
