Cisco D9858 - Page 137

Setup Menu
115
Inband
Menu Item
Description
Parameters
PE
This selects the transcoder
index as referenced by DPM.
PE1 or PE2
Note: The single channel transcoder
(D9858-1) supports one Program
Entry (PE1) only.
Apply Inband
This applies the uplink
parameters for transcoding,
such as bitrate, GOP and
resolution, to the local
transcoder settings for the
selected program entry. This is
only supported with an uplink
that uses uplink transcoding
controls for the user address of
the selected program entry.
Yes or No
TS Out - Options
To view the Options menu from the TS Out menu, press the RIGHT arrow key four
times.
The Options menu allows you to configure auto synchronization and fixed output
options for the MPEG over IP and ASI outputs.