Cisco D9858 User Manual

Chapter 5 Web GUI Setup and Monitorin g
208
ii In the Channel Numbers Offset field, set the subsequent PE channel
numbers. For example, if the First Channel Number is set to 100 and the
Channel Numbers Offset is set to 10, then the first channel number is 100,
and the second channel number is 110.
b From the Use Input PMT PID Numbers drop-down list, choose Yes to use
the input PMT PID number. Otherwise, choose No (default) to use the first
PE PID number and PID offset number assigned below.
i In the First Channel First ES PID Number field, set the first PE PMT PID
number. The default is 1701.
ii In the PMT PID Numbers Offset field, set the offset of the subsequent PE
PMT PID numbers. For example, if the First Channel First ES PID
Number is set to 1701 and the PMT PID Numbers Offset is set to 1, then
the first PMT PID number is 1701, and the second PMT PID number is
1702.
c From the Use Input ES PID Numbers drop-down list, choose Yes to use the
input ES PID number. Otherwise, choose No (default) to use the first ES PID
number and the ES PID offset number assigned below.
i In the First Channel First ES PID Number field, set the first ES PID
number. The default is 101.
ii In the First ES PID Numbers Offset field, set the offset of the subsequent
ES PID numbers. For example, if the First ES PID Number is set to 101
and the ES PID Numbers Offset is set to 100, then the first ES PID number
is 101, and the second ES PID number is 201.
d From the Use Input PMT ES Stream Order drop-down list, choose Yes to
assign the ES PID according to the incoming PMT order. Otherwise, choose
No to use the reserved PIDs defined below.
i In the PCR, VID, AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT,
ETV fields, set the number of PIDs for the specified streams (PCR, VID,
AUD, SUBT, VBI, DPI, MPE, TTX, DATA, LSD, CDT, ETV) in one
channel.
e Click OK.
4 From the Enable Auto Map For Auxiliary PEs drop-down list, choose Yes for
the DPM to set the output actions for all the auxiliary PEs to MAP when the
Output Mode is set to Transcode. If the Enable Fixed Table Output is set to Yes,
the output configuration for the auxiliary PEs is determined by the fixed output
table options when you resynchronize the output channels and PIDs to match
the input programs.
Note: The DPM resolves any output conflicts automatically, even if the Enable
Auto Fix for Collision is set to No.
5 Click Apply.

Cisco D9858 Specifications

General

Brand	Cisco
Model	D9858
Category	Receiver
Language	English