Chapter 5 Web GUI Setup and Monitorin g
Removes the service and its associated PMT reference from the
transport output.
Provides the flexibility to define all the outgoing PID numbers for
a PE, including those not currently on transmission.
11 In the Stream Type field, enter the stream type to map within a PE to a specified
PID (0 to 255).
12 From the Category drop-down list, choose the output program stream service
type. This value is only used if the Action is set to Map. The categories are:
UNKN, CDT, LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID, PCR or
INVL.
13 In the Instance and Output PID fields, enter the output stream instance (1 to 64)
and the output program PID (0 to 8192).
14 If Action is set to Map, enter the output PID number (0 to 8192) in the Output
PID field.
15 Click Save.
16 Click OK.
To remove a PID mapping, click the radio button of the entry you want to
remove and click Delete.
Synchronizing the Inputs
1 In the DPM Program Entry Setup table, each PE output can be synchronized to
its input according to one of the four output modes. Click the radio button of the
program entry you want to synchronize and then click Resynchronize or click
Resynchronize All to synchronize the inputs to the outputs according to the
service assignments only. The Confirm Resynchronization window is displayed.
2 Click whether you want to synchronize the PE output according to the services
and then the PIDs assigned to each service, services only, PIDs only, or to
synchronize using a template.
Resynchronize Program, PMT
PID, ES List & ES PIDs
The transcoder will synchronize the PE output according
to the services and then the PIDs assigned to each
service.
To Next Page
Loading...
Need help?
General
