Cisco D9858 - Page 299

277
Alarm
Message
Type
Message
Cause/Remedy
Description
Severity
ID
Transcoder
Status
Set
Transcoder Not
Detected
Cause: Possible
hardware or
software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Messages
were not
received from
Transcode on
boot.
Major
1500
Transcoder
Status
Set
Lost Contact With
Transcoder
Cause: Transcoder
resetting. Possible
hardware or
software fault.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Messages
were not
received from
Transcoder
after it
previously
received
messages.
Major
1500
Transcoder
Status
Clear
Transcoder Started
–
–
Major
1500
Transcoder
Verification
Set
Post reported
errors
Cause: Possible
hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
The
transcoder
power-on self-
test reported
errors.
Major
1600
Transcoder
Verification
Set
Post data
unavailable
Cause: Possible
hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
The
transcoder
was unable to
read the
results of the
power-on self-
test.
Major
1600
Transcoder
Verification
Set
Application
checksum failed
Cause: Possible
hardware issue.
Remedy: Clear all
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
The
transcoder
software
failed
verification.
Major
1600