Cisco D9858 User Manual

Chapter 4 Front Panel Operation
74
Protocols
The Protocols menu allows you to control remote access protocols (Telnet, SSH, HTTP, DTX,
and SNMP) to the IRD.
Menu Item
Description
Port Number
Parameters
Telnet
Controls Telnet access to the
IRD. Select Enable to allow
Telnet connections. Select
Disable to disable the listener for
the Telnet port.
TCP port #23
Enable (default) or Disable
SSH
Controls SSH access to the IRD.
Select Enable to allow secure
shell connections. Select Disable
to disable the listener for the
SSH port.
TCP port #22
Enable (default) or Disable
HTTP
Controls HTTP access to the
IRD. Select Enable to allow web
connections. Select Disable to
disable the listener for the HTTP
port.
TCP port #80 for
HTTP
TCP port #443
for HTTPS.
Disable - Disables the
listener for the HTTP port.
Enable (default) - Allow
web connections.
Secure - Encrypted access
to the webserver (HTTPS).
For more information, see
Protocol Control Settings
(on page 231).
SNMP
Controls SNMP access to the
IRD. Select Enable to allow
SNMP connections. Select
Disable to disable the listener for
the SNMP port.
UDP port #161
Enable (default) or Disable
MPE
Sets whether the MPE data is
forwarded to the network.
Note: The transcoder supports
up to a maximum of 10 Mbps
throughput when forwarding
1500 byte packets.
N/A
Fwd None - The MPE data
is not forwarded to the
network.
Fwd All - All the MPE data
is forwarded to the
network.
Fwd Filtered - Only the
MPE data from the defined
Static Multicast Filtering
table is forwarded to the
network. For more
information on configuring
the Static Multicast
Filtering table, see To Add a
Static Multicast Filtering
(on page 237).

Cisco D9858 Specifications

General

Brand	Cisco
Model	D9858
Category	Receiver
Language	English