Cisco Firepower 4100

DescriptionField
DCX Recieved 100 PDUs without ACK
IP QOS DCBXP compat check failed
Suspended due to minlinks
parent interface down
Inactive - M1 port not allowed in FabricPath-mode VLAN
The speed supported by the transceiver does not match the speed configured on the
port
Transceiver authentication failed on the port
Failed to bring up vPC+ peer link Fabric Path switch ID not configured
Failed to bring up vPC+ peer link port is not configured as a Fabric Path port
The transceiver has failed ethernet compliance
Speed-Group config does not match type of transceiver
Suspended due to no LACP PDUs received from peer
Interface speed:
Auto – auto-negotiated
10 – 10 Mbps
100 – 100 Mbps
Auto110 – auto-negotiated between 10 and 100 Mbps
1000 – 1 Gbps
10G – 10 Gbps
a-10 – auto-negotiated, 16 Mbps
a-100 – auto-negotiated, 106 Mbps
a-1000 – auto-negotiated, 1006 Mbps
a-10G – auto-negotiated, 10006 Mbps
40G – 40000 Mbps
100G – 100000 Mbps
a-40G – auto-negotiated, 40006 Mbps
a-100G – auto-negotiated, 100006 Mbps
A (D) appended to a speed entry indicates a dedicated interface, while (S)
indicates it is shared.
Note
Speed
ID number of the port channel to which interface is assigned, if any.Port channel #
Cisco Firepower 4100/9300 FXOS Command Reference
290
S Commands
show interface brief (connect fxos)