Cisco IE 4000 Software Configuration Guide

79
Cisco Systems, Inc. www.cisco.com
Configuring Cisco IOS Configuration
Engine
Prerequisites for Configuring Cisco IOS Configuration
Engine
Set the CNS DeviceID
 When using the Cisco Configuration Engine user interface, you must first set the DeviceID field to the hostname value
that the switch acquires after, not before, you use the cns config initial global configuration command at the switch.
Otherwise, subsequent cns config partial global configuration command operations malfunction.
Enable Automated CNS Configuration
 To enable automated CNS configuration of the switch, you must first complete the prerequisites in Table 1. When
you complete them, power on the switch. At the setup prompt, you do not need to enter a command. The switch
begins the initial configuration as described in the Initial Configuration, page 83. When the full configuration file is
loaded on your switch, you do not need to do anything else.

Cisco IE 4000 Specifications

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports