941
Configuring IPv6 Unicast Routing
Configuring IPv6
DETAILED STEPS
Command Purpose
1. configure terminal Enter global configuration mode.
2. ipv6 dhcp pool poolname Enter DHCP pool configuration mode, and define the
name for the IPv6 DHCP pool. The pool name can be
a symbolic string (such as Engineering) or an integer
(such as 0).
3. address prefix IPv6-prefix lifetime {t1 t1 |
infinite}
(Optional) Specify an address prefix for address
assignment.
This address must be in hexadecimal, using 16-bit
values between colons.
lifetime t1 t1—Specify a time interval (in
seconds) that an IPv6 address prefix remains in
the valid state. The range is 5 to 4294967295
seconds. Specify infinite for no time interval.
4. link-address IPv6-prefix (Optional) Specify a link-address IPv6 prefix.
When an address on the incoming interface or a
link-address in the packet matches the specified IPv6
prefix, the server uses the configuration information
pool.
This address must be in hexadecimal, using 16-bit
values between colons.
5. vendor-specific vendor-id (Optional) Enter vendor-specific configuration mode,
and enter a vendor-specific identification number.
This number is the vendor IANA Private Enterprise
Number. The range is 1 to 4294967295.
6. suboption number {address IPv6-address |
ascii ASCII-string | hex hex-string}
(Optional) Enter a vendor-specific suboption number.
The range is 1 to 65535. Enter an IPv6 address, ASCII
text, or a hex string as defined by the suboption
parameters.
7. exit Return to DHCP pool configuration mode.
8. exit Return to global configuration mode.
9. interface interface-id Enter interface configuration mode, and specify the
interface to configure.
To Next Page
Loading...
Need help?
General
