Cisco NCS 2000 series

• AU-AIS, on page 129
• AU-LOP , on page 130
• AUTH-EC, on page 131
• AUTO-SENSE, on page 131
• AUTO-SENSE-DSBLD, on page 132
• AUTORESET , on page 132
• AUTOSW-AIS , on page 133
• AUTOSW-AIS-SNCP , on page 134
• AUTOSW-LOP (STSMON) , on page 135
• AUTOSW-LOP-SNCP , on page 135
• AUTOSW-PDI , on page 136
• AUTOSW-PDI-SNCP, on page 137
• AUTOSW-SDBER, on page 137
• AUTOSW-SDBER-SNCP , on page 138
• AUTOSW-SFBER , on page 139
• AUTOSW-SFBER-SNCP , on page 139
• AUTOSW-UNEQ (STSMON) , on page 140
• AUTOSW-UNEQ-SNCP (VCMON-HP), on page 141
• AWG-DEG , on page 142
• AWG-FAIL , on page 142
• AWG-OVERTEMP , on page 143
• AWG-WARM-UP , on page 143
• BAD-DB-DETECTED, on page 144
• BAT-FAIL , on page 144
• BP-LPBKFACILITY, on page 145
• BP-LPBKTERMINAL, on page 146
• CARLOSS (EQPT) , on page 147
• CARLOSS (FC) , on page 149
• CARLOSS (GE) , on page 149
• CARLOSS (ISC) , on page 150
• CARLOSS (TRUNK) , on page 151
• CASETEMP-DEG , on page 152
• CD, on page 153
• CFM-CONFIG-ERROR, on page 154
• CFM-LOOP, on page 155
• CFM-MEP-DOWN , on page 156
• CFM-XCON-SERVICE , on page 156
• CHANLOSS, on page 157
• CHAN-PWR-THRESHOLD-CHECK, on page 158
• CLDRESTART , on page 159
• COMP-CARD-MISSING, on page 159
• COMM-FAIL, on page 160
• COOL-MISM, on page 161
• CP-UNVER-CLEARED Alarm, on page 162
• CTNEQPT-MISMATCH , on page 162
• DATA-CRC, on page 163
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
100
Alarm Troubleshooting