EasyManuals Logo

Cisco NCS 2000 series Troubleshoot Manual

Cisco NCS 2000 series
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #530 background imageLoading...
Page #530 background image
DescriptionError/Warning MessageError/Warning
ID
There was an error during node
selection.
An error occurred during node selection.EID-2024
Refer to the error or warning message
text. For example, this error is
generated from the node view
Provisioning> WDM-ANS> tabs to
indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card
view (Ethernet card only), where it
indicates that the back-end spanning
tree protocol (STP) disabling is not
supported.
This feature cannot be used. Verify that each endpoint
of this circuit is running software that supports this
feature.
EID-2025
Error occurred while attempting to
switch a path protection circuit away
from a span.
The {0} request could not be applied. {1}EID-2026
CTC could not delete the circuit drop.An error occurred while deleting the circuit drop.EID-2027
CTC could not remove the circuit
node.
An error occurred while removing the circuit node.EID-2028
The task you are trying to complete is
not supported by CTC.
The requested operation is not supported.EID-2029
There was an error during
provisioning.
An error occurred during provisioning.EID-2030
There was an error while adding a
node.
An error occurred while adding the node.EID-2031
CTC could not rename the circuit.The circuit could not be renamed. {0}EID-2032
There was an internal error while
validating the user changes after the
Apply button was pressed. This error
can occur in the Edit Circuit dialog
box or in the BLSR table in the shelf
view (rare condition).
An error occurred during validation. {0}EID-2033
Refer to the error message text.Network circuits could not be added: {0}EID-2034
Refer to the error message text.The source and destination nodes are not connected.EID-2035
You cannot delete the DCC/GCC link
as it is needed to access the node.
The {0} cannot be deleted. LAN Access has been
disabled on this node and this {0} is needed to access
the node.
EID-2036
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
484
Error Messages
Error Messages Reference

Table of Contents

Other manuals for Cisco NCS 2000 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 2000 series and is the answer not in the manual?

Cisco NCS 2000 series Specifications

General IconGeneral
BrandCisco
ModelNCS 2000 series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals