Cisco NCS 2000 series

DescriptionError/Warning MessageError/Warning
ID
An internal error occurred in Network
Alarm tab while synchronizing alarms
with the nodes.
A communication error occurred: {0}EID-2056
There was an error during the node
deletion.
An error occurred while deleting the node. {0}EID-2059
CTC could not find any protection
channel access (PCA) circuits for this
task.
No PCA circuits were found.EID-2060
There was an error defining the
VLAN.
An error occurred while provisioning the VLAN.EID-2061
Refer to the error message text.An error occurred while deleting VLANs. No VLAN(s)
were selected. Please select a VLAN.
EID-2062
The selected VLAN is the default
VLAN and cannot be deleted.
The default VLAN cannot be deleted.EID-2063
There was an error deleting the
specified VLAN.
An error occurred while deleting VLANs. {0}EID-2064
Cannot import the profile because the
profile has reached the maximum
number of copies in the editor.
The profile cannot be imported. The profile "{0}" exists
in the editor and the maximum number of copies (ten)
exists in the editor. The import will be aborted. The
profile has already been loaded eleven times.
EID-2065
CTC encountered an error while trying
to store the profile.
The profile could not be stored. An error occurred while
writing to {0}.
EID-2066
CTC encountered an error while
writing the specified file.
An error occurred while writing to the file. {0}EID-2067
CTC encountered an error trying to
load the alarm profile from the node.
The alarm profile could not be loaded from the node.EID-2068
Either the specified file was not found,
or there was an input/output exception.
The file could not be found or an I/O exception
occurred. {0}
EID-2069
There was a failure in deleting the
specified profile.
The profile could not be deleted. {0}EID-2070
You cannot select more than one
column during clone action.
Only one column may be highlighted.EID-2071
You cannot select more than one
profile.
Only one profile may be highlighted.EID-2072
You cannot delete a permanent
column.
This column is permanent and cannot be removed.EID-2073
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
486
Error Messages
Error Messages Reference