ComAp InteliCompact NT

InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
170
Setpoint: CAN Bus Mode
Group
Comms Settings
Range [units]
32C, 8C [-]
Related
applications
MINT
Description
CAN bus speed selection.
 32C: High speed CAN (250 kbps) applicable for up to 32 controllers,
CAN bus length limited to 200 meters.
 8C: Low speed CAN (50 kbps) applicable for up to 8 controllers,
CAN bus length limited to 900 meters.
NOTE:
Use low speed for a long-distance connection only. Set all connected
controllers to the same speed.
Setpoint: IBLite IP Addr
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
If DHCP is DISABLED this setpoint is used to adjust the IP address of the
Ethernet interface of the controller. Ask your IT specialist for help with this
setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which
has been assigned by the DHCP server.
Setpoint: IBLite NetMask
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
If DHCP is DISABLED this setpoint is used to adjust the IP address of the
Ethernet interface of the controller. Ask your IT specialist for help with this
setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which
has been assigned by the DHCP server.
Setpoint: IBLite GateIP
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
If DHCP is DISABLED this setpoint is used to adjust the IP address of the
gateway of the network segment where the controller is connected.