ComAp InteliCompact NT

InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
173
Setpoint: SMTP UserName
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
Use this setpoint to enter the username for the SMTP server.
Setpoint: SMTP UserPass
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
Use this setpoint to enter the password for the SMTP server.
Setpoint: SMTP Server IP
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
This setpoint is used for entering the domain name (e.g.
smtp.yourprovider.com) or IP address (e.g. 74.125.39.109) of the SMTP
server. Ask your internet provider or IT manager for this information.
HINT:
You may also use one of the free SMTP servers, e.g. smtp.gmail.com.
However, note that some free SMTP servers may cause delays (up to
several hours) when sending e-mails.
If you do not want to send active e-mails, you may leave this setpoint blank,
as well as other setpoints related to SMTP server and e-mail settings.
Proper setting of SMTP-related setpoints as well as the controller mailbox
are essential for sending alerts via e-mails
Setpoint: Contr MailBox
Group
Comms Settings
Range [units]
[-]
Related
applications
All
Description
Enter an existing e-mail address in this setpoint. This address will be used
as the sender address in active e-mails that will be sent from the controller.