ComAp InteliCompact NT

InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
67
Iveco ADEMIII (Vector)
Yes
Yes
Yes
*
Iveco EDC (Cursor)
No
No
Yes
*
John Deere
No
No
Yes
*
Perkins ECM
No
No
Yes
*
Perkins 1300
No
Yes
No
SISU EEM3 Genset
No
No
Yes
*
Caterpillar J1939
No
No
Yes
*
DDC DDEC IV/V
No
No
Yes
*
VM Industrial
No
No
Yes
*
VM Marine
No
Yes
Yes
MAN MFR
Yes
Yes
Yes
SISU EEM3
Yes
Yes
No
GM MEFI6
No
No
Yes
*
GM SECM
No
No
Yes
*
GM e-control
No
No
Yes
GM e-control LCI
No
No
Yes
ISUZU ECM
Yes
Yes
Yes
DaimlerChrysler ADM2
Yes
Yes
Yes
JCB Delphi
No
No
Yes
* standard TSC1 frame
NOTE:
Support for electronics engines was unified with the InteliLite
NT
Comap controller family. Please use
the ECU List version 5.9 or higher for proper function with the InteliCompact
NT
2.0 firmware. ECU List
5.9 is part of the IC-NT 2.0 Installation Suite.
Support of new ECU types is continuously added to the new firmware releases. If you cannot find your
ECU type in the list, please download the latest release of the document ComAp Electronic Engines
Support from http://www.comap.cz or contact technical support for more information.