ComAp InteliDrive DCU Industrial - Page 108

InteliDrive DCU Industrial 3.4.0 Global Guide
108
Setpoint group Basic settings Related FW 3.4.0
Range [units] [hh:mm:ss]
Default value 0:00:00
Force value
Alternative config
Step [-]
Comm object 10199 Related applications AS, SS
Description
See Timer Repeat (page 108) description.
Timer OFF
6 back to List of setpoints
Setpoint group Basic settings Related FW 3.4.0
Range [units] [Never, Mon-Fri, Mon-Sat, Mon-Sun, Sat-Sun ]
Default value NEVER
Force value
Alternative config
Step [-]
Comm object 10045 Related applications AS, SS
Description
Logical binary output Timer Active is closed when actual time is over the Timer ON and opened when actual
time is over Timer OFF. The function depends on Timer Repeat settings. The output is closed when
controller is switched On and Timer settings corresponds to closed state.
Timer Repeat
6 back to List of setpoints