InteliDrive DCU Industrial 3.4.0 Global Guide
142
Setpoint group Load sharing Related FW 3.4.0
Range [units] [DISABLED, ENABLED]
Default value DISABLED
Force value
Alternative config
Step [-]
Comm object 9921 Related applications AS
Description
Enables Wrn OthrCommEr warning message when no other unit is recognized on the CAN bus.
OTHRCOMMER (PAGE 223) is closed in this case.
DetectOtherCAN
6 back to List of setpoints
Setpoint group Load sharing Related FW 3.4.0
Range [units] 0 .. 1000 [%]
Default value 5
Force value
Alternative config
Step 1
Comm object 10136 Related applications AS
Description
Average value calculated from all Speed Request values of controllers running in Loadsharing mode together
(on the same CAN2 bus). See Load sharing block diagram (page 144).
RQSP Aver
6 back to List of setpoints
To Next Page
Loading...
