InteliDrive DCU Industrial 3.4.0 Global Guide
167
Related FW 3.4.0 Related applications AS, SS
Comm object 5
Description
Active Binary input switches ID-DCU Industrial display backlight between two adjustable intensity levels.
Alternative intensity of the backlight can be set independently by ID-DCU Industrial panel buttons:
1. Hold Enter and press Page to switch to ID Info screen (from any measure screen)
2. Hold Enter and pres / ¯ arrow key to increase/decrease display brightness
The adjusted intensity is stored in non-volatile memory.
Note: Both backlight levels are default (from production) set to maximum.
Low Brightness
6 back to List of LBI
Related FW 3.4.0 Related applications AS, SS
Comm object 16
Description
Active input blocks protections that are configured as “Force Block 1” Prot. block type. Corresponding
setpoint is ForceBlockDel1.
Force Block 1
6 back to List of LBI
Related FW 3.4.0 Related applications AS, SS
Comm object 17
Description
Active input blocks protections that are configured as “Force Block 2” Prot. block type. Corresponding
setpoint is ForceBlockDel2.
Force Block 2
6 back to List of LBI
Related FW 3.4.0 Related applications AS, SS
Comm object 18
Description
Active input blocks protections that are configured as “Force Block 3” Prot. block type. Corresponding
setpoint is ForceBlockDel3.
Force Block 3
6 back to List of LBI
To Next Page
Loading...
