Commander Connect Connect V6 - To Configure Line Key Lights; To Prohibit Trunk-To-Trunk Calls on a Station; External Diversion Options

Commander Connect Owners Manual
99
To configure Line Key Lights
When a call is placed on System Hold, you can decide if the associated Line Key Light is to flash
or remain steady on all other Keystations. The default setting is that the light flashes.
From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘System’
• Press the Scroll Down Key () until ‘Line key light’ is displayed
• Select ‘Line key light’
• Choose either ‘Light flashing on hold’ or ‘Light steady on hold’.
Press the Hands-free Key to finish programming.
To prohibit trunk-to-trunk calls on a Station
You may prohibit individual Stations from activating External Divert, External Transfer and
External Conference. (These features set up so-called trunk-to-trunk calls).
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘External Diversion’ is displayed and select.
• Select ‘No trunk-to-trunk calls’
• Select the Stations to be denied this feature. Those Stations denied the feature are
indicated by a ♦.
Press the Hands-free Key to finish programming.
External diversion Options
This allows you to decide if External callers or External and internal Callers to your Station are
diverted externally if you have set an external divert. It also allows Stations to be prohibited from
activating an external diversion.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘External Diversion' is displayed
• Select 'External diversion'
• Select ‘No trunk to trunk calls’
• Select the Stations that are not allowed to activate an external diversion or set up
trunk to trunk calls.
• If both internal and external calls are to be diverted select 'All calls'.
• If external calls only are to be diverted select 'External calls only'