Commander Connect Owners Manual
98
To configure disconnected Stations
The system assumes that all available Station interfaces have devices connected to them. If a
Station interface does not have a device connected, ensure correct system operation by
disconnecting the Station interface in system programming, as follows
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘Station disconnect’ is displayed
• Select ‘Station disconnect’
• Select the Stations you wish to connect or disconnect. Disconnected Stations are
denoted by a ♦.
Press the Hands-free Key to finish programming.
Note: When a Keystation is connected to a Station interface that is programmed as
disconnected, the Keystation 'Display' may appear as if the Keystation is connected.
However, when the Handset is lifted a busy tone is heard and no options will be displayed.
To examine system passwords
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘Examine passwords’ is displayed
• Select ‘Examine passwords’
• Select either ‘Station lock password’, or ‘Voicemail password’, or ‘Answering Machine’
• If you selected ‘Station lock password’, the Station menu will appear. Select a
Station and its Station Lock Password will appear on the 'Display'
• If you selected ‘Voicemail password’, the Station menu will appear. Select
Voicemail a Station and its Voicemail Password will appear on the 'Display'
• If you selected Voicemail ‘Answering Machine’, the Answering Machine Password
appears on the display.
Press the Hands-free Key to finish programming.
To Next Page