Commander Connect Owners Manual
89
Answering a Door Station call
You can answer a Door Station call if your Station is programmed to ring when someone calls at
the Door Station.
To answer a 'Door Station' call, lift the Handset and speak. There is no code to dial.
Note: A Station cannot make a call to a Door Station
To open a door using the Doorstrike
When your Station is ringing with a Door Station call, and you have a Doorstrike mechanism
installed, the option ‘Open the door’ will be displayed
Select ‘Open the Door’. The Doorstrike relay will operate and the call to the Door Station will
be disconnected.
From a standard telephone, the code is R731 if you are on a call, and 731 if you are not on a
call.
To program which Stations can operate the Doorstrike
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘Open door restriction’ is displayed
• Select ‘Open door restriction’
• Select which Stations are restricted from opening the door. The Stations restricted
from operating the Doorstrike will be indicated with a ♦.
Press the Hands-free Key to finish programming.
Note: By Default, all stations are unable to open the door.
To program how long the Door remains unlocked
You can program how long the door remains unlocked to suit your requirements.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘System’
• Press the Scroll Down Key () until ‘Timers’ is displayed
• Select ‘Timers’
• Press the Scroll Down Key () until ‘Open the Door’ is displayed
• Select “Open the Door’
• Enter the new time between 01 and 30 seconds
• Press ‘Confirm’
Press the Hands-free Key to finish programming.
To Next Page
Loading...