Commander Connect Connect V6 - To Prevent Your Number Being Sent on an Individual Call; To Prevent Numbers Being Sent on All Station Calls; To Prevent Numbers Being Sent When Answering a Call on All Stations; To Program Stations to Have a Minimum 3.1 Khz Bandwidth

Commander Connect Owners Manual
113
To prevent your number being sent on an individual call
MSN/DDI numbers are also sent to the network as the Calling Line Identity for presentation to
the called party. You can prevent your number being presented to the called party as follows:
• Press the ISDN Key
• Select ‘Set CLIR’
• Enter the number you wish to call and select ‘Send to line’. The call is placed with the
CLIR service activated.
To prevent numbers being sent on all Station calls
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘Permanent CLIR’ is displayed
• Select ‘Permanent CLIR’
• Select the Stations whose numbers you do not wish to send to the network. The
Stations that will not have their numbers presented are indicated with a ♦.
Press the Hands-free Key to finish programming.
To prevent numbers being sent when answering a call on all Stations
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System Programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Station’
• Press the Scroll Down Key () until ‘Permanent COLR’ is displayed
• Select ‘Permanent COLR’
• Select the Stations whose numbers you do not wish to send to the network. The
Stations that are selected are indicated with a ♦.
Press the Hands-free Key to finish programming.
To Program Stations to have a minimum 3.1kHz bandwidth
This feature allows Stations to be programmed to have a minimum speech bandwidth of 3.1kHz.
This is used when a modem or fax machine is connected to a Station and the unit is equipped
with ISDN lines.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘3.1kHz Stations’ is displayed
• Select ‘3.1kHz Stations’
• Select the Stations on which you wish to enable the feature. The Stations with the
feature enabled are indicated by a ♦.
Press the Hands-free Key to finish programming.