Commander Connect Connect V6 - Reminder Call; To Set Your Station to Give You a Reminder Call at a Given Time; To Review and Cancel a Reminder Call; Station Reset

Commander Connect Owners Manual
51
Reminder Call
This feature enables you to set your Station to ring at a given time.
To set your Station to give you a Reminder Call at a given time
• From the Idle Menu, press the Scroll Down Key () until ‘Reminder Call’ is displayed
• Select ‘Reminder call’
• Enter the time in the 24-hour clock format, for example, 1423 for 2.23 pm
• Press ’Confirm’
At the programmed time the Station will give ten rings. If not answered, it will ring twice more at
two-minute intervals and will then cancel.
Note: Alarm calls must be set daily and therefore cannot be set more than 24hrs ahead.
To review and cancel a Reminder Call
• To review a Reminder Call, select ‘Reminder Call’ and the time set will be displayed.
Select ‘Confirm’ to retain the programmed time. If you wish to change the time, select
‘Change’ and enter a new time
• To cancel the reminder call, select ‘Change’ followed by ‘Confirm’.
From a standard telephone, the code 718 is used to set a Reminder Call, and the code 718
*
is
used to cancel it. A standard telephone cannot query the Reminder Call time.
Station Reset
You can reset your Station to cancel all the following features if they have been set:
• Do Not Disturb
• Call Divert
• Call Back
• 'Display' Messaging
• Reminder Call
To reset your Keystation
• From the Idle Menu, press the Scroll Down Key () to scroll downwards until ‘Reset the
telephone’ is displayed
• Select ‘Reset the telephone’. The 'Display' shows ‘Station reset’ momentarily before
returning to the Idle Menu
If you are using a standard telephone, dial 739 and wait for the acknowledgement tone
(internal dial tone).