Commander Connect Owners Manual
72
Dialling # when Listening to a Information-Only Voice Mailbox
The call is presented to the destination set in the Incoming Ringing programming for the line.
Remote Notification of Voice Messages
When a user turns remote notification on, a call will be made to the personal number
programmed by the user to notify them that they have received a new voice mail message.
The user can set up remote notification to notify them of all new messages or only those marked
as priority by callers to their voice mail.
Remote notification can be turned on and off as required.
If the call is to a personal number the user can access their voice mail when they answer the call
by entering their voice mail password and pressing #.
Setting Up your Remote Notification to a Personal Number
You must first program the personal that the system is to call when a new message is received.
Then select whether all messages or messages marked as priority are notified. Finally you turn
remote notification on.
Programming a Personal Number
• Press the MESSAGE key.
• Select “Voice Messaging”.
• Enter your station number (which is your voice mailbox number).
• Enter your voice mail password (1111 by default) followed by #.
• Scroll down until ‘Remote Notification’ is displayed
• Select “Remote Notification”.
• Select “Programming”.
• Select “Personal Number”.
• Select “Change”.
• Enter the number and press ‘confirm’.
From a standard phone dial 4311 to program a personal number
Notification of All Messages or Priority messages
• Press the MESSAGE key.
• Select “Voice Messaging”.
• Enter your Station number (which is your voice mailbox number).
• Enter your voice mail password (1111 by default) followed by #.
• Scroll down until ‘Remote Notification’ is displayed
• Select “Remote Notification”.
• Select “Programming”.
• Select “Priority Messages Only” or “All Messages”.
From a standard phone, dial 433 for priority messages and 434 for all messages.
To Next Page
Loading...