Commander Connect Owners Manual
97
Miscellaneous system configuration options
To change the Programming Station
System programming can only be carried out at one Keystation, that is, the Keystation
connected to the Programming Station. By default, Station 20 is the Programming Station. The
Programming Station can be changed to any other Station if required, except for the PA station.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘System’
• Select ‘Programming position’
• Select the Station you wish to have as the Programming Station. The selected
Programming Station is denoted by a ♦.
Press the Hands-free Key to finish programming.
Note: The PA station and MOHI (music on hold interface) station will not appear on the
display as an option for the programming station.
To change the System Programming Password
The default System Programming Password (1111) can be changed to any 4-digit number.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘System’
• Select ‘Change password’
• Select ‘Change’ and enter the 4-digit number you require
• Select ‘Confirm’.
Press the Hands-free Key to finish programming.
To configure unequipped Line interfaces
The system assumes that available Line interfaces have exchange lines connected to them. If a
line interface does not have an exchange line connected ensure correct system operation by un-
equipping the line interface in system programming, as follows:
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Lines’
• Press the Scroll Down Key () until ‘Equipped Lines’ is displayed
• Select ‘Equipped lines’
• Select the lines you wish to equip or unequip. Equipped lines are denoted by a ♦.
Unequipped lines are denoted by a ◊.
Press the Hands-free Key to finish programming.
To Next Page
Loading...