Commander Connect Owners Manual
106
Programming Dialtone Detection
This feature is provided as a programmable option under PSTN programming and is enabled to
prevent the system from dropping the line when dial tone has not been detected. When enabled
dial tone is not detected and the line is released if no digit is dialled until the expiration of the
"Dialling time-out timer"
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Lines’
• Press the Scroll Down Key () until ‘PSTN programming’ is displayed
• Select ‘PSTN programming’
• Press the Scroll Down Key () until 'Disable dialtone detect' is displayed
• Select 'Dialtone detection' The lines with 'Dialtone detection' programmed are
indicated with a ♦
Routing calls to Phantom mailboxes
The Incoming ringing and CLI programming are modified so that calls can be routed directly to
Phantom Mailboxes. The addition of this programming means that some PSTN Lines can be
answered by Phantom Mailboxes. These can be programmed as message only boxes allowing
separate information only lines to be set up.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Lines’
• Press the Scroll Down Key () until ‘Incoming Ringing’ is displayed
• Select ‘Incoming Ringing’
• Select which Line and which mode you wish to use
• Select ‘Other’ and then select ‘Phantom mailbox’
Press Handsfree key when finished
To Next Page
Loading...