Commander Connect Connect V6 - To Divert Calls to a Secretary; Least Cost Routing; To Set up Codes to Allow Calls to be Routed on Specific Lines or Networks

Commander Connect Owners Manual
41
To divert calls to a Secretary
When this feature is set, all calls to the Manager’s Station will be diverted to the Secretary’s
Station.
• From the Manager's Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘Key Programming’ is displayed
• Select ‘Key programming’
• Select the key you want to program
• Press the Scroll Down Key () until ‘Divert all calls’ is displayed
• Select ‘Divert all calls’
• Select ‘Enter data’ and enter the Secretary’s Station number
• Select ‘Confirm’.
Press the Hands-free Key to finish programming.
Least Cost Routing
You may use this feature to have users’ calls routed over specific lines, or over a specific
Network Provider. To set the feature up you associate input codes with the lines over which
calls should be routed and with whatever network codes are necessary to route the call.
In addition, you can choose to route the calls over different lines at various times of the day for
optimum call rates. Once the facility is activated calls are automatically routed over the selected
lines, and the network code is sent to the line before the telephone number.
To set up codes to allow calls to be routed on specific Lines or
networks
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Lines’
• Scroll Down and select ‘LCR Codes'
• Select LCR On to activate the facility
• Enter in a code index (01-50)
• Enter an input code (Up to 5 digits). Press Confirm. This is the code dialled by the
user.
• Enter an Output Code (Up to 9 digits). This is the code that will be inserted before the
telephone number that the user dials. This code can be used to select a specific
Network Provider
• Select the preferred or exclusive option.
If ‘Exclusive’ is selected the calls can only be sent on the lines selected below.
If ‘Preferred’ is selected the calls will be routed on any available Line, if none of the
selected lines are available. In this case the output code is not dialled.
Note: When Enabling or Disabling the LCR feature the new setting does not take immediate
affect. There can be a delay a of up to 1 minute for the setting to take affect.