Commander Connect Connect V6 - Restricting Outgoing Calls; To Restrict a Station from Accessing a Particular Exchange Line; To Program Exchange Lines to be Used for Incoming Calls Only; Outgoing Groups

Commander Connect Owners Manual
55
Restricting outgoing calls
This feature lets you decide which lines each Station can access for outgoing calls. By default,
all Stations have access to all lines.
To restrict a Station from accessing a particular exchange Line
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Lines’
• Press the Scroll Down Key () until ‘Outgoing restriction’ is displayed
• Select ‘Outgoing restriction’
• Select the Line
• Select the Stations to be prevented from accessing that line. A ♦ is displayed alongside
those Stations that are restricted from accessing the line, and a ◊ is displayed alongside
those Stations that have access to the line.
Press the Hands-free Key to finish programming.
To program exchange lines to be used for incoming calls only
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Lines’
• Press the Scroll Down Key () until ‘Incoming calls only’
• Select ‘Incoming calls only’
• Select the lines that are to be used for incoming calls only. Lines programmed for
incoming calls only will be indicated by a ♦ alongside.
Press the Hands-free Key to finish programming.
Outgoing Groups
To program Lines into groups for access using the codes 0, 760 - 769
‘Exchange Lines’ can be grouped together in up to eleven Outgoing Groups. Each Outgoing
Group is associated with a code. These codes are 0, 760 - 769, with Group 1 being associated
with 0, etc. Dialling a code selects a Line from the associated Outgoing Group.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Lines’
• Press the Scroll Down Key () until ‘Outgoing groups’ is displayed
• Select ‘Outgoing groups’
• Select the Group you wish to set up. Up to eleven Groups can be set up, each with a
corresponding access code – 0, 760 - 769
• Select the lines to be in the Group. The lines in the Group are indicated by a ‘♦’.
Press the Hands-free Key to finish programming.
Note: Lines can be in one Outgoing Group only. Selecting a Line to be a member of a Group
automatically removes it from all other Groups.