Commander Connect Connect V6 - Flexible Numbering

To Next Page

To Previous Page

Commander Connect Owners Manual

101

Flexible numbering

The Station numbers, Line access digits, and first digit of the feature codes can be changed.

This allows systems with DDI Numbers to have their Station number reflect the DDI number.

• When the Station numbers are changed they can only be of 3 or 4 digits.

• From the Programming Station, press the PROGRAM Key

• Select ‘System programming’

• Enter the System Programming Password

• Select ‘Stations’

• Press the Scroll Down Key () until ‘Flexible numbering' is displayed

• Enter the number length from 3 or 4 digits

• Enter the first Station number (that Station 20 is to be changed to)

• Press confirm.

The system will automatically allocate the remaining numbers

If the range selected conflicts with the current programming the switch will automatically set a

range which does not have a conflict. The option to manually adjust the numbering may then be

selected, the conflicting numbers reprogrammed, and the range then reset to the required

numbers.

Once the numbers have been automatically reallocated it is also possible to manually adjust the

numbers for the following: Station numbers, Misc. Stations, Line access, Operator code, Feature

code, Speed dial.

Once the above procedure is completed

• Select 'Manual Adjustment'

• Select either 'Station numbers' or 'Other codes'

• If 'Station numbers' select the required Station and change the number

• If 'Other codes' is selected

• Select one of the options: Misc. Stations, Line access, Operator code, Feature code,

Speed dial

• The current number is displayed for 2 seconds

• Enter the new number required

• Press confirm

• If there is a conflict 'Invalid' is displayed and another number must be entered

• Repeat this procedure for all required options.

Note: The "Misc. Stations" option covers 'Group numbers', 'S

Stations' and 'Phantom mail

box numbers'.