Commander Connect Connect V6 - Getting Started - Basic Call Features; Making and Answering Calls; To Make an External Call; To Make an Internal Call

To Next Page

To Previous Page

Commander Connect Owners Manual

Getting started – basic call features

Making and answering calls

To make an external call

• Lift the Handset and select a free Line in one of the following ways:

• Press the Line Key 1 for Line 1, Line Key 2 for Line 2, and so on. (This is applicable

only if the Programmable Keys are programmed as Line Keys, which is the default

programming)

• Dial 0, (to select a Line from Outgoing Group 1)

• Dial 760 - 769, (to select a Line from Outgoing Groups 2 to 11 respectively)

• Dial the telephone number you require. Digits are sent to line as they are dialled.

Note: If you do not lift the Handset then you may enter digits in Pre-dial mode, digits will not be

sent for processing until you lift the Handset, press the Hands-free key, or select 'Dial' from the

'Display'. You can edit the number you have entered prior to sending to the line, by using the

left-hand Keypad ‘Edit Key’(), located below the keypad.

Note: If you are entering an external number in Pre-dial mode, enter 0, 760 - 769 to have a line

selected when you send the digits for processing.

To make an internal call

You can place an internal call in one of the following ways:

• Select the ‘Internal Call’ option on the 'Display' and select the desired Station from the

list

• Dial the Station number (20 – 59 ) and select 'Dial'

• Lift the Handset and dial the Station number.

The 'Display' will show the Station number, or, if programmed, the Station name.

From a standard telephone, go off-hook and dial the Station number.

To call a Group

You can call any of the 20 Groups in one of the following ways:

• Select the ‘Internal call’ option on the 'Display' and select the desired group from the

group list which is located under ‘Other’

• Dial the Group number (180 - 199) and select ‘Dial’