Commander Connect Connect V6 - To Program a Station for Use with a Public Address Amplifier; To Make an Announcement over a Public Address System; To Respond to a Page over the PA System; To Make an Announcement over the Speakers of All Keystations

Commander Connect Owners Manual
37
To program a Station for use with a Public Address amplifier
A Station with a Public Address amplifier connected must first be programmed for use with a PA
amplifier.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘System’
• Press the Scroll Down Key () until ‘PA amplifier’ is displayed
• Select ‘PA amplifier’
• Select ‘PA equipped’
• Select the Station to which PA system is connected.
Press the Hands-free Key to finish programming.
Note: The station that has been programmed as the Programming station will not be display
as an option on the screen.
Note: The station that has been programmed as the PA Station will be indicated by ’’ next to
the station.
To make an announcement over a Public Address system
If there is a Public Address (PA) system connected to your Commander Connect any Station
can make an announcement over the PA system.
• From the Idle Menu, press the Scroll Down Key () until ‘Paging’ is displayed
• Select ‘Paging’
• Select ‘Public Address’ and make your announcement. The announcement can last a
maximum of fifteen seconds.
Note: Do not hang up if you want the paged party to be able to respond directly to your page.
From a standard telephone, the code is 720.
To respond to a page over the PA system
If you have been paged over the PA the PA Answer feature puts you in direct contact with the
paging Station, provided that the person who paged you has not replaced the Keystation.
• When you are paged, select ‘Answer page’ on the nearest Keystation and you will be
connected to the paging Station.
From a standard telephone, the code is 717.
To make an announcement over the speakers of all Keystations
The Internal Paging feature allows any Station to make an announcement over the speakers of
all Keystations. Only Keystations that are page-protected will not be paged.
• From the Idle Menu, press the Scroll Down Key () until ‘Paging’ is displayed
• Select ‘Paging’
• Select ‘Page all Keystations’
• Make your announcement.
From a standard telephone, the code is 716.