Commander Connect Connect V6 - To Make an Announcement over the Speakers of All Keystations and the PA; To Make a Call over the Speaker of Another Keystation; To Answer a Voice Call at Your Station; To Protect Keystations against Announcements and Voice Calls

Commander Connect Owners Manual
38
To make an announcement over the speakers of all Keystations and the
PA
The 'Page All' feature allows any Station to make an announcement over the speakers of all
Keystations and the PA amplifier. Only Keystations that are page-protected will not be paged.
• From the Idle Menu, press the Scroll Down Key () until ‘Paging’ is displayed
• Select ‘Paging’
• Select ‘Page all’
• Make your announcement.
From a standard telephone, the code is 795.
To make a call over the speaker of another Keystation
The Voice Call feature allows you to speak over the speaker of an individual Keystation. If the
Keystation is page-protected the voice call will fail.
• From the Idle Menu, press the Scroll Down Key () until ‘Voice call’ is displayed
• Select ‘Voice call’
• Select the Station you wish to page
• Make your announcement.
From a standard telephone, the code is 715.
To answer a Voice Call at your Station
• Press the Mute Key and speak in Hands-free Mode, or pick up the Handset.
To protect Keystations against Announcements and Voice Calls
By default, all Keystations may be paged. You can page-protect each Keystation to prevent it
from being paged from either Announcements or Voice Calls.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Stations’
• Select ‘Page protection’
• Select the Stations you wish to protect. A ‘♦’ will be displayed beside protected
Stations.
Press the Hands-free Key to finish programming.
To prevent Stations from using the Public Address system
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Stations’
• Press the Scroll Down Key () until ‘Restrict use of PA’ is displayed
• Select ‘Restrict use of PA’
• Select the Stations you wish to prevent from using the PA system. A ‘♦’ is displayed
beside the Stations that are restricted.
Press the Hands-free Key to finish programming.