Commander Connect Owners Manual
50
To examine Station Lock Passwords
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Stations’
• Select ‘Examine passwords’
• Select ‘Station lock password’
• Select the Station. The Lock Password is briefly displayed on the top line of the
'Display'.
Press the Hands-free Key to finish programming.
Tone protection
As described on page 30, Stations may present a busy Station with a Call Waiting tone,
provided the busy Station is not protected against receiving Call Waiting tones. By default, all
Stations are protected against receiving Call Waiting tones, except station 20. However, you
may program Stations to receive Call Waiting tones.
To Program a Station to receive Call Waiting tones
• From the Programming Station, select the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘Stations’
• Press the Scroll Down Key () until ‘Tone protect’ is displayed
• Select ‘Tone Protect’
• Select the Stations you wish to allow receive Call Waiting tones. A ◊ is displayed beside
those Stations allowed to receive Call Waiting tones, and a ♦ is displayed beside those
Stations protected against receiving Call Waiting tones. (By default, all Stations will
have a ♦ displayed except station 20).
Press the Hands-free Key to finish programming.
To protect an individual call from Call Waiting tones
If your Station can receive Call Waiting tones, you may protect each call on an individual basis
from interruption.
• When you are on a call, select ‘Tone protect’ on the 'Display'.
From a standard telephone, the code is R725.
To Next Page
Loading...