Commander Connect Connect V6 - To Change the Ringing Time before Calls Receive the Courtesy Greeting; To Change the Time before Unanswered Calls Are Disconnected; Press the Hands-Free Key to Finish Programming; To Have Callers Receive a Customised Courtesy Greeting

Commander Connect Owners Manual
65
To change the ringing time before calls receive the Courtesy greeting
You can change the time that a call will ring before being automatically answered by the
Courtesy Service, as follows:
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘System’
• Press the Scroll Down Key () until ‘Timers’ is displayed
• Select ‘Timers’
• Press the Scroll Down Key () until ‘Courtesy Delay’ is displayed
• Select ‘Courtesy delay’
• Enter the time required in seconds, (01 - 30)
• Press ‘Confirm’.
Press the Hands-free Key to finish programming.
To change the time before unanswered calls are disconnected
You can change the time that a call will ring before being automatically disconnected by the
Courtesy Service, as follows:
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘System’
• Press the Scroll Down Key () until ‘Timers’ is displayed
• Select ‘Timers’
• Press the Scroll Down Key () until ‘Courtesy service length’ is displayed
• Select ‘Courtesy service length’
• Enter the time required in seconds, (001 - 300). Default is 180 secs.
• Press ‘Confirm’.
Press the Hands-free Key to finish programming.
To have callers receive a customised Courtesy greeting
When a Voice Module is installed, you can program the Courtesy Service feature to select the
Voice Module as the source of the message. This allows you to customise the Courtesy Service
by recording the message you wish returned to the caller.
To record a customised Courtesy greeting
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password and select ‘System’
• Press the Scroll Down Key () until ‘Change greetings’ is displayed
• Select ‘Change greetings’
• Select ‘Courtesy service day’ or ‘Courtesy service night’ to record the ‘Day Service’ and
‘Night Service’ greetings respectively
• Select ‘Record greeting’
• When prompted, speak and record the new greeting
• When finished recording of the new greeting, press ‘Confirm’.
Press the Hands-free Key to finish programming.