Commander Connect Connect V6 - Naming Analogue Lines; Turning on the Line Name Feature; Room Monitor

Commander Connect Owners Manual
107
Naming Analogue lines
This feature allows a PSTN line to present a name of the line to a station. The name will be
presented in a similar format to the Tele-secretary feature in ISDN. So when a call is presented
to a station on that line the topline of the display will read "Call for XXX", where XXX is the name
Programmed for that line.
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Lines’
• Press the Scroll Down Key () until ‘PSTN programming’ is displayed
• Select ‘PSTN programming’
• Press the Scroll Down Key () until ‘Line Name’ is displayed
• Select ‘Line Name’. All the available Analogue lines will appear on the screen
• Select the required line and enter the name as required.
Press the handsfree key when finished.
Turning on the ‘Line Name’ feature
• From the Programming Station, press the PROGRAM Key
• Press the Scroll Down Key () until ‘System programming’ is displayed
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘System’
• Press the Scroll Down Key () until ‘Present Line Name’ is displayed
• Select ‘Present Line Name’. A ♦ diamond indicates the feature is enabled.
Press the handsfree key when finished.
Room Monitor
When a station activates “Room Monitor” and leaves the phone off hook, stations 20 and 21 can
dial that station and are connected to it.
• Press the handsfree key or lift the handset
• Press the Scroll Down Key () until ‘Room Monitor’ is displayed
• Select “Room Monitor”.
Leave the phone off hook
Stations 20 and 21 can call the phone and are connected directly to it.
All other stations calling the ‘Room monitor’ station are returned busy tone.
From a standard analog phone, dial 798 and remain off hook.
To cancel the facility, go on hook.