Commander Connect Owners Manual
121
Outgoing Restriction
Switch equipped with a PRI Access
If the switch is programmed with a PRI Access only this option is not presented on the Line
programming Menu.
If the switch is equipped with Lines as backup 'Outgoing restriction' is programmed as follows:
• From the Programming Station, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password
• Select “Lines”.
• Press the Scroll Down key () until “Outgoing Restriction” is displayed.
• Select “Outgoing Restriction” option.
• The menu updates to show only the back up lines equipped (Line 31 - Line 34 or
Access 1- 2)
• Select the required line
• The Station menu is displayed.
• Select the Stations to be restricted from selecting the line for outgoing calls.
• In default no restriction applies.
Incoming calls only when PRI is programmed
When Incoming calls only is selected when the switch is equipped with a PRI Access the display
updates showing the B-Channels and backup lines and are programmed as follows:
• From the Programming Station, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password
• Select “Lines”.
• Press the Scroll Down key () until “Incoming Calls Only” is displayed.
• Select “Incoming Calls Only” option.
• The menu updates to show all B channels and the back up lines/Accesses
• Select the required lines to be reserved for incoming calls only.
• In default no lines are programmed.
Note: If 30 B-Channels are available and 10 lines are selected then a total of 20 B-Channels
are available to stations to select for outgoing calls.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the
message 'Restricted' is shown on the display.
To Next Page
Loading...