Commander Connect Owners Manual
120
Incoming Ringing / Auto Attendant / Courtesy Service
If a PRI Access and no backup lines are installed then the Incoming Ringing is programmed
as follows:
• From the Programming Station, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password
• Select “Lines”.
• Select “Incoming Ringing” option.
• The menu updates to show only the 'PRI' option
• Select 'PRI Access'
• Select “Day”, “Night”, or “Day and Night”.
• If the line is to ring an individual Station, select “Station” and then the required Station.
If the line is to be presented to a group, select “Group” and then the required group.
• Auto Attendant or Courtesy Service can also be associated with the call
Press the Hands-free key to finish programming.
The default is that all lines ring group 1 in both day and night modes.
If the switch is equipped with a PRI Access and some Backup Lines are equipped then Incoming
ringing is programmed as follows:
• From the Programming Station, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Select “Incoming Ringing” option.
• Select either 'PRI Access' or Line 31 - Line 34 or Access 1 - 2
Continue the programming as described above
In the case of PRI the B-channels cannot be separated so the full PRI is programmed to ring a
Station or group. It can also be programmed for Courtesy or Auto Attendant service.
Note: Lines 31 - 34 or Access 1 - 2 are the backup lines. Only those equipped are displayed.
Note: No D-Channel backup is provided for the PRI Line.
To Next Page
Loading...