Commander Connect Owners Manual
100
To move a faulty Station
If a Station interface becomes faulty, you can swap its Station programming to a different
Station. Calls for the faulty Station will be routed to the new Station.
• From the Programming Station, press the PROGRAM Key
• Select ‘System programming’
• Enter the System Programming Password
• Select ‘Stations’
• Press the Scroll Down Key () until ‘Port Swapping’ is displayed
• Select ‘Port swapping’
• Select the faulty Station from the Station list
• Select the new Station from the Station list.
Press the Hands-free Key to finish programming.
To Change ringing from 50 to 25 Hz
This option allows the ringing frequency to be changed from the default 50Hz to 25 Hz on
individual Stations
• From the Programming Station, press the PROGRAM Key
• Select ‘System programming’
• Enter the System Programming Password
• Select 'Stations'
• Press the Scroll Down Key () until ‘50 Hz ringing' is displayed
• Select '25 Hz ringing'
• Select the Stations to ring at 25 Hz
• Press the handsfree key to finish programming
Note: The default is that all Stations are set for 50 Hz ringing.
Reverse cadence
The external and Internal ringing cadences can be interchanged on a Station by Station basis
• From the Programming Station, press the PROGRAM Key
• Select ‘System programming’
• Enter the System Programming Password
• Select 'Stations'
• Press the Scroll Down Key () until ‘Reverse Cadence' is displayed
• Select 'Reverse Cadence'.
• Select the Stations that require the cadences changed
Keypad Feedback
The keystations provide confidence tones while digits are being dialled. This can be disabled on
a Station by Station basis
• From the Programming Station, press the PROGRAM Key
• Select ‘System programming’
• Enter the System Programming Password
• Select 'Stations'
• Press the Scroll Down Key () until ‘Keypad feedback' is displayed
• Select 'Keypad Feedback'.
• Select the Stations for which confidence tones are not required
To Next Page
Loading...