incorrect.
---------------------------------------------------------------------------
Screen is blank. QuickBlank is initiated. Enter password to exit
QuickBlank.
-------------------------------------------------------
Another screen blanking Press any key and/or enter
utility may be password.
installed.
-------------------------------------------------------
Screen save was Press any key or click the
initiated by Power mouse.
Management due to lack
of user activity.
-------------------------------------------------------
If a color STN is used, Adjust the slide controls on
brightness/contrast the right side of the
control slide needs display for
adjusting. brightness/contrast. *
-------------------------------------------------------
Display (lid) switch is Tap the switch.
stuck.
-------------------------------------------------------
Display has overheated. If computer is in direct
sunlight, move it and allow
it to cool off.
---------------------------------------------------------------------------
Display is blank System is in Standby. Press the standby button to
and the exit Standby.
power/standby LED
is flashing.
===========================================================================
Problem Probable Cause Solution(s)
===========================================================================
Screen is blank, System has entered a If available, immediately
the power/standby low battery Standby connect the computer to an
LED is flashing, condition. The computer external power source or
and the battery will next activate insert a charged battery
LED is flashing. Hibernation, if this pack. Then press the standby
feature is not disabled. button to exit Standby.
If another power source is
not immediately available
and Hibernation is disabled,
attempt to exit Standby and
save any open files.
However, the computer may
not have enough power to do
this.
If you have not disabled
Hibernation, the computer
automatically hibernates.
Do not interfere with the
computer while it is
entering Hibernation.
Once the computer has
turned off, insert a charged
battery pack, or connect the
computer to another power
source. Then turn the