D-Link DFL-260E

Parameters
poolname
2.28.7. proxyarp_failed (ID: 05600008)
Default Severity
ERROR
Log Message
Could not add dynamic ProxyARP route. NATPool <poolname>
Explanation
It was not possible to dynamically add a core route for the given IP
address.
Gateway Action
None
Recommended Action
Try to configure a core route with ProxyARP manually.
Revision
1
Parameters
poolname
ip
2.28.8. max_states_reached (ID: 05600009)
Default Severity
WARNING
Log Message
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing lingering state <replacedip>
Explanation
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem will try to replace the oldest
lingering state.
Gateway Action
replace_lingering
Recommended Action
Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
Revision
1
Parameters
poolname
num_states
replacedip
2.28.9. max_states_reached (ID: 05600010)
Default Severity
WARNING
Log Message
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing active state <replacedip>
Explanation
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem must replace an active state since
no lingering states exist.
Gateway Action
replace_active
Recommended Action
Increase the MAXSTATES variable for this NATPool if more
2.28.7. proxyarp_failed (ID: 05600008) Chapter 2. Log Message Reference
339