D-Link DFL-260E

filetype
Context Parameters
ALG Module Name
ALG Session ID
2.1.108. resumed_compressed_file_transfer (ID: 00200254)
Default Severity
WARNING
Log Message
FTPALG: The file <filename> (File type: <filetype> ) cannot be sent
to antivirus scan engine.
Explanation
Decompression module cannot decompress a file that has been
resumed. The file is allowed without any further scanning since Fail
Mode is Allow.
Gateway Action
allow_data_without_scan
Recommended Action
Update Fail-Mode parameter if the file should be blocked.
Revision
2
Parameters
filename
filetype
Context Parameters
ALG Module Name
ALG Session ID
2.1.109. failed_to_send_response_code (ID: 00200255)
Default Severity
NOTICE
Log Message
FTPALG:Failed to send the response code.
Explanation
The FTP ALG could not send the correct response code to the client.
Gateway Action
none
Recommended Action
None.
Revision
1
Context Parameters
ALG Module Name
2.1.110. illegal_command (ID: 00200267)
Default Severity
WARNING
Log Message
FTPALG: REST from <peer> not allowed, rejecting command
Explanation
The client tried to issue a "REST" command, which is not valid since
the client is not allowed to do this. The command will be rejected.
Gateway Action
rejecting_command
Recommended Action
If the client should be allowed to do issue "REST" commands, modify
2.1.108. resumed_compressed_file_transfer
(ID: 00200254)
Chapter 2. Log Message Reference
79